Service Manual

87
OCH636B
12-1-1. Selecting functions using the wired remote controller <PAR-4xMAA ("x" represents 0 or later)>
Main Main menu
Service
F1 F2 F3 F4
Service menu
Cursor
Select: SELECT
Enter maintenance password
unem ecivreS
rosruC
: RETURNunem niaM
Test run
Input maintenance info.
Settings
Check
Others
Service menu
Service menu:
RETURN
Not available.
Please stop the unit.
2
When the Service menu is selected, a window will appear asking for the pass-
word.
To enter the current maintenance password (4 numerical digits), move the
cursor to the digit you want to change with the F1
or F2 button.
Set each number (0 through 9) with the
F3
or
F4
button.
Then, press the [SELECT] button.
1
Select "Service" from the Main menu, and press the [SELECT] button.
*At the main display, the menu button and select "Service" to make the
maintenance setting.
Maintenance password is required
3
If the password matches, the Service menu will appear.
The type of menu that appears depends on the connected indoor
units’ type.
A screen will appear that indicates the setting has been saved.
Navigating through the screens
• To go back to the Service menu .............. [MENU] button
• To return to the previous screen ............... [RETURN] button
<Service menu>
Note: The initial maintenance password is "9999". Change the default
password as necessary to prevent unauthorized access. Have the
password available for those who need it.
: If you forget your maintenance password, you can initialize the
password to the default password "9999" by pressing and holding
the
F1
button for 10 seconds (PAR-4xMAA) or
F1
and
F2
buttons simultaneously for 3 seconds (PAR-3xMAA) on the main-
tenance password setting screen.
Note: Air conditioning units may need to be stopped to make cer-
tain settings. There may be some settings that cannot be
made when the system is centrally controlled. (As for PAR-
4xMAA, the units need to be stopped only at "Settings".)
F1 F2 F3 F4
MENU
ON
OFF
RETURN
SELECT
HOLD