Engineering Manual

PAC-SH91MK-E/PAR-SA92MW-E/PAR-SL93B-E
Electrical box cover
{
Electrical box fixing screw
Electrical box cover fixing screw
Beam
Also on the
opposite side
• Pass the lead wire through the retaining clips.
• Layout the lead wire along the vane motor lead wire, then fix them
with the clips on the ceiling side of the unit.
Retaining clip
Clips on the ceiling side
• Remove the beam.
• Loosen the two screws at the bottom of the electrical box cover,
and then slide the cover to the left to remove it.
• Pull down the electrical box.
<Wonly when wireless remote controller kit with i-see sensor PAR-SA92MW-E or wireless remote controller receiver
PAR-SL93B-E is used. >
• Pass the cord through the bush at the top right of the electrical box.
• Connect the connector to CN90 on the right of the control board.
• If the cord is loose, bundle it using the clamps under the above bush.
CN6Y CN4Y CN90
Bush
Clamp
Clamp
* The positions of the connectors may be different according to the model.
Please refer to the wiring diagram to confirm the positions of the connectors.
7 Connecting the i-see sensor lead wire (radiation temp. sensor (black) and the stepping motor connector (transparent))
to the control circuit board
<Wonly when wireless remote controller receiver PAC-SH91MK-E or wireless remote controller kit with i-see sensor
PAR-SA92MW-E is used. >
• Pass the cord through the bush at the top right of the electrical parts case.
• Connect the radiation temp. sensor (black) lead wire to CN4Y (white) on the control circuit board.
• Connect the stepping motor (transparent) lead wire to CN6Y (red) on the control circuit board.
8 Reinstalling the removed components
• Reinstall the removed components in reverse order. (The brand label case is not needed.)
9 Remote control holder
• To install the wireless remote controller on a wall, first attach the remote control holder to a wall.
1
3
2
Fitting remote control into holder
1 Fix the remote control holder to the wall using
the 2 wood screws provided.
2 Insert the remote control into the holder.
3 Push the remote control against the wall.
Removing remote control
● Pull the top of remote control forward.
NOTE : The remote signal will reach the receiver over a distance of approx. 7m (23 ft.) in a straight line and
approx. 45° left or right. If the infrared receiver is affected by fluorescent light (especially, inverter type),
it may not be able to receive the signal. Take this into consideration when installing fluorescent lights or
replacing them.
4 Laying out the lead wire
5 Removing the beam and the electrical box cover
6 Connecting the receiver board connector to the control circuit board
261