Engineering Manual

Applicable Models
How to Install
Making Sure of Components
PCA-A24/30/36/42KA7
i-see Sensor
Controller Kit with i-see Sensor
Wireless Remote Controller Kit
PAC-SH91MK-E
PAR-SA92MW-E
PAR-SL93B-E
Make sure that the following components, along with this manual, are packed in the box.
Component PAC-SH91MK-E PAR-SA92MW-E PAR-SL93B-E
i-see sensor 1 – –
Wireless remote controller receiver with i-see sensor – 1 –
Wireless remote controller receiver – – 1
Wireless remote controller – 1 1
Remote control holder – 1 1
“AAA” LR03 alkaline batteries – 2 2
4.1×16 wood screws – 2 2
Cord retaining clips – 2 2
Connection cord xing seal (12×30 size) – 1 1
3 Installing to the indoor unit
• Pass the lead wire through the right side of the square hole to which the brand label case was attached, and then
pull them through the slit in the right side of the bottom panel.
•
Fit the receiver or i-see sensor into the square hole where the brand label case was attached.
1 Removing the intake grille and the right side panel
• Slide the catch holding the intake grille backwards to open the grille. Remove the screw holding the side
panel, and then slide the side panel forward to remove it.
Side panel
Slide forward
Catch retaining the intake grille
Remove the screw holding the side panel
Slide
Slide
• Remove the brand label case (name plate with MITSUBISHI ELECTRIC) from the bottom right of the unit. If it is
difficult to remove the case, use a flat-blade screwdriver, etc., taking care not to damage the panel.
Panel
Case
Panel
Lead wire
(for i-see sensor)
Retaining clip
Slit
Lead wire
(for receiver)
2 Removing the existing brand label case
W
Be sure to turn the power off before installing.
260