Operation Manual

9
3.Operation
Reset 1
horizontal
2 3 4 5
Note:
TheoutletNo.isindicatedbythenumberofgroovesonbothendsof
eachairoutlet.Settheairdirectionwhilecheckingtheinformation
shownontheremotecontrollerdisplay.
Horizontal airow
Downward
Outlet No.4
Electric Component box
Outlet No.1
Air outlet identication marks
Outlet No.3 Outlet No.2
Remote controller setting
The airow direction of this outlet
is controlled by the airow direc-
tion setting of remote controller.
Fixed
The airow direction of this outlet is xed
in particular direction.
* When it is cold because of direct
airow, the airow direction can be
xed horizontally to avoid direct airow.
<Howtosetthexedup/downairdirection>
Notes:
● Thisfunctioncannotbesetdependingontheoutdoorunittobe
connected.

• For SLZ-KF
.
NA series, only the particular outlet can be xed to certain
direction with the procedures below. Once xed, only the set outlet is
xed every time air conditioner is turned on. (Other outlets follow UP/
DOWN air direction setting of remote controller.)
■
Explanationofword
• “Refrigerant address No.” and “Unit No.” are the numbers given to
each air conditioner.
• “Outlet No.” is the number given to each outlet of air conditioner.
(Refer to the illustration below.)
•“Up/Down air direction” is the direction (angle) to x.
3.5.2Vane
<Accessingthemenu>
F1 F2 F3 F4
Main
Main display:
Cursor Page
Main menu
Vane·Louver·Vent. (Lossnay)
High power
Timer
Weekly timer
OU silent mode
<Vanesetting>
F1 F2 F3 F4
Fri
Swing Off
LouverVent.Vane
<ReturningtotheMainmenu>
F1 F2 F3 F4
Main
Main display:
Cursor Page
Main menu
Vane·Louver·Vent. (Lossnay)
High power
Timer
Weekly timer
OU silent mode
Select "Vane·Louver·Vent.
(Lossnay)" from the Main menu
(refer to page 8), and press the
[SELECT] button.
Press the [F1] or [F2] button to go
through the vane setting options:
"Step 1", "Step 2", "Step 3", "Step
4", "Step 5", "Swing" and "Auto".
Select the desired setting.
Swing
Auto
Select "Swing" to move the vanes
up and down automatically.
When set to "Step 1" through "Step
5", the vane will be fixed at the
selected angle.
Press the [RETURN] button to go
back to the Main menu.
Step 1
Step 4
Auto
Step 2
Step 5
Notes:
●
Duringswingoperation,thedirectionalindicationonthescreen
doesnotchangeinsyncwiththedirectionalvanesontheunit.
● Availabledirectionsdependonthetypeofunitconnected.
●
 Inthefollowingcases,theactualairdirectionwilldifferfromthe
directionindicatedontheremotecontrollerdisplay.
 1.Whilethedisplayisin“STANDBY”or“DEFROST”states.
 2.Immediatelyafterstartingheatmode(whilethesystemiswait-
ingforthemodechangetotakeeffect).
 3.Inheatmode,whenroomtemperatureishigherthanthetem-
peraturesetting.
Step 3
Swing
BH79A345H01_en.indd 9 2018/05/25 14:59:41