Engineering Manual

Decoration panel with 3D i-see sensor PLP-40EAEU

5. Installing the intake grille (Fig. 11)

Note:

Whenreinstallingthecornerpanels(eachwithasafetystrapattached),con-

necttheotherendofeachsafetystraptothegrilleasshownintheillustration.

* If the corner panels are not attached surely, they may fall off while the main unit

is operating.

• Perform the procedure that is described in “2. Preparing to attach the grille” in

reverse order to install the intake grille and the corner panel.

• The direction of the intake grille can be changed according to the wishes of the

customer.

A Screw (4 × 16)

B Corner panel

C Safety strap

D Hook

E Refrigerant pipe

F Drain pipe

G Company logo

* Installation in any position is possible.

H Initial position of the levers on the intake grille

* Although the clips can be installed in any of 4 positions, the conguration shown

here is recommended. (It is not necessary to remove the intake grille when

maintenance is performed on the electrical box of the main unit.)

Fig. 11

170