Engineering Manual

Wireless Signal Receiver PAR-FA32MA-E
(1) Choose a place in which to install the Signal Receiving
Unit (switch box). Be sure to observe the following steps:
When installing on either the switch box or the wall,allow space
around the Signal Receiving Unit as shown in the figure on the right.
When installing the Signal Receiving Unit to the switch box, the Signal
Receiving Unit slipped downward for 6.5 mm (1/4 inch) as right illustrated.
Parts which must be supplied on site.
Switch box for one unit
Thin-copper wiring pipe
Lock nut and bushing
lnstall the unit on the wall or ceiling where the signal is received from
the remote controller.
(Refer to the below illustration)
90˚
Max. 7m (22 ft)
Install the Signal Receiving Unit where is watched from any position.
NOTE: lf the Signal Receiving Unit is installed near a fluorescent lamp specially inverter type,signal interception
may occur. Be careful for installing the Signal Receiving Unit or replacing the lamp.
(2) Install the remote control cord to the terminal block (No polarity).
Remote controller Cord
ø10 (13/32)
When concealed wire, the hole ø10 (13/32) to push a remote
control cord through is necessary on the ceiling.
Signal Receiving Unit
2
Insert the minus screwdriver toward the
arrow pointed and wrench it to remove the cover.
A flat screwdriver whose width of blade is between
4 and 7 mm (5/32 - 9/32 inch) must be used.
Remote control cord
Push a remote control cord
through the wires installed hole.
1
70
(
2-3/4
)
6,5
(
1/4
)
83,5
0,4
(
3-9/32
)
Signal receiving
unit external
Center of
Switch box
Switch box
Installation pitch
Unit : mm (in)
Protrusion
(pillar, etc)
Example: Ceiling cassette type, Ceiling concealed type
Indoor unit
(3) Installing hole when the Signal Receiving Unit is installed on
the wall direct.
• Cut the thin-wall portion inside the bottom case (oblique section) by a knife
or a nipper.
• Take out the connected remote control cord to the terminal brock through
this space.
Thin-wall portion
Bottom case
How to Install
257