Engineering Manual

Wireless Signal Receiver PAR-FA32MA-E
Setting pair number of the wireless remote controller and the Signal Receiving Unit.
Set switch position of the Signal Receiving Unit as follows.
Refer to the installation manual that came with the wireless remote controller for how to set pair numbers of wireless
remote controllers.
(1) Change the pair number switch to set the pair number.
1 Pair number
To fix the Signal Receiving Unit which operates from the wireless remote controller.
10 kinds of setting (0 - 9) are available for the wireless remote controller and Signal Receiving Unit.
Adapt a pair number to the using wireless remote controller.
1 2 3
0
9
8
7
6
5
4
3
2
1
PAR-FA32MA
Pair No. of receiver
matches that of re-
mote controller.
Main/Sub switch
(Factory setting
“main”)
Seal
Signal Receiving Unit
(Externals removing the cover)
Pair number switch
(Factory setting “0”)
0
9
8
7
6
5
4
3
2
1
“0”
“0”
“1”
“1”
“2”
“2”
“3”
“3”
“0” “0”
“0”
“0” “0”
“0”
“0”
“0”
“0”
Separate setting
Each unit can only be operated by its own wireless
remote controller.
Single setting
All the units can be operated by a single wireless remote
controller.
2
-2 When setting in different rooms.
Assing a different number to each wireless remote
controller and all the Signal Receiving Unit
(Leave the setting as purchase)
2 Setting example
2
-1 When setting in same room.
(2) Main/Sub switch settings (leave the initial “Main” setting when not using the MA remote controller).
Set the Main/Sub switch when using with the MA remote controller (PAR-20MAA).
Set the signal receiving unit to “Sub” and the MA remote controller (PAR-20MAA) to “Main”.
Setting the Pair Number & Main/Sub Switch
256