Specifications

109
[Procedure]
1. Press the CHECK button twice.
2. Press the temperature
buttons.
3. Point the remote controller at the
sensor on the indoor unit and
press the HOUR button.
4. Point the remote controller at the
sensor on the indoor unit and
press the ON/OFF button.
ON/OFF
TEMP
FAN
VANE
MODE
CHECK
LOUVER
TEST RUN
AUTO STOP
AUTO START
h
min
RESET
SET
CLOCK
CHECK
CHECK
display
Temperature
button
CHECK
button
Refrigerant
address
display
HOUR
button
ON/OFF
button
•"CHECK" lights, and refrigerant
address "00" flashes.
•Check that the remote controller's
display has stopped before continuing.
•Select the refrigerant address of the
indoor unit for the self-diagnosis.
Note: The refrigerant address is set using
the outdoor unit's dip switch (SW1).
(For more information, see the
outdoor unit installation manual.)
•If an air conditioner error occurs, the
indoor unit's sensor emits an intermittent
buzzer sound, the operation light
flashes, and the inspection code is
output.
•The check mode is released.
OCT03-E-4.qxp 04.3.26 1:52 PM Page 109