Unit installation
38
^
. Unit Function Setting by the Remote Controller (for Mr. SLIM)
Each function can be set according to necessity using the remote controller. The setting of function for each unit can only be
done by the remote controller. Select available function from the table. (For details regarding initial settings and operation modes
of each unit, refer to the unit installation manual.)
(1) Itemised functions of the entire refrigerant system (select unit number 00)
Function Settings Mode No. Setting No. Check Remarks
Power failure
automatic recovery
OFF
1
1
ON 2
Indoor temperature
detecting
*1
Average data from each indoor unit
2
1
Data from
the indoor unit with remote controller 2
Data from
main remote controller 3
LOSSNAY
connectivity
Not supported
3
1
Supported
(indoor
unit does not intake outdoor air
through LOSSNAY)
2
Supported (indoor
unit intakes outdoor air through
LOSSNAY)
3
Power
voltage
240V
4
1
220V,
230V 2
Auto operating
mode
*2
Auto energy-saving
operation ON
5
1
Auto
energy-saving
operation OFF 2
Frost prevention
temperature
2
:(Normal)
15
1
3: 2
Defrosting control
Standard
17
1
For
high
humidity 2
Refrigerant leakage
setting(%)
*3
70% (RP35, 50) / 80% (RP60-140, HRP)
21
1
50% (RP35,
50) / 60% (RP60-140, HRP) 2
*1. Can be set only when a wired remote controller is used. This function cannot be set for floor type models.
When using 2 remote controllers (two-remote controller operation), the remote controller with built-in sensor must be set as a main remote
controller.
*2. Can be set only when the outdoor unit is an inverter type.
*3. Can be set only when the outdoor unit is (H)RP type.
Meaning of "Function setting"
Mode02 : indoor temperature detecting
No indoor temperature(ta)
No.1 Average data of the
sensor on all the
indoor units
Intial
setting
ta=(A+B)/2 ta=(A+B)/2 ta=A ta=A
No.2 The
data
of the sen-
sor on the indoor unit
that connected with
remote controller
ta=A ta=B ta=A ta=A
No.3 The data
of the sen-
sor on main remote
controller.
ta=C ta=C ta=C ta=C
OUTDOOR
INDOOR
REMOTE
(MAIN)
REMOTE
(SUB)
INDOOR
OUTDOOR
INDOOR
REMOTE
(MAIN)
REMOTE
(SUB)
INDOOR
OUTDOOR
INDOOR
REMOTE
(MAIN)
REMOTE
(SUB)
OUTDOOR
INDOOR
REMOTE
(MAIN)
Perform the following settings only to change the functions for Mr. Slim series.
(This setting is not possible with the City-Multi series.)