Operation Manual

Replacement of light bulbs
9-36 Vehicle care and maintenance
9
2. Remove the screws (A), and then move
the light unit toward the rear of the vehi-
cle to unfix the notch (B) and pins (C).
3. Turn the socket counterclockwise and
remove it, and then pull the bulb out of
the socket.
4. To install the bulb, perform the removal
steps in reverse.
N00929101080
1. Push the light unit upward to remove it.
D- Rear turn signal light
E- Tail light and stop light (LED) - cannot
be replaced
NOTE
 The rear side-marker light, tail light and stop
light use an LED instead of the bulb.
Check with an authorized Mitsubishi Motors
dealer or a repair facility of your choice
when the light needs to be repaired or
replaced.
NOTE
 When mounting the light unit, align the
notch (F) and pin (G) on the light unit with
the clip (H) and hole (I) in the body.
Back-up lights
NOTE
 Wrap a cloth around the tip of the screw-
driver to keep from scratching the lens.
BK0223400US.book 36 ページ ２０１５年２月１３日 金曜日 午後１２時１５分