Operation Manual

Replacement of light bulbs
Vehicle care and maintenance 9-37
9
3. Turn the socket counterclockwise and
remove it, and then remove the bulb from
the socket by turning it counterclockwise
while pressing in.
4. To install the bulb, perform the removal
steps in reverse.
N00929101064
1. Push the light unit toward the center of the
vehicle body to remove it.
2. Turn the socket (A) counterclockwise to
remove it, and then pull the bulb out of
the socket.
3. To install the bulb, perform the removal
steps in reverse.
D- Tail and stop light (bulb type, if so
equipped)
E- Rear turn signal light
NOTE
 The rear side-marker light and the tail and
stop light (LED type) use an LED instead of
the bulb.
Check with an authorized Mitsubishi Motors
dealer or a repair facility of your choice
when the light needs to be repaired or
replaced.
NOTE
 When mounting the light unit, align the
notch (F) and pin (G) on the light unit with
the clip (H) and hole (I) in the body.
Back-up lights
NOTE
 Wrap a cloth around the tip of the screw-
driver to keep from scratching the lens.
NOTE
 When installing the light unit, first insert the
notch (B) into the hole on the body, and then
push on the light unit to fit it into place.
BK0211800US.book 37 ページ ２０１４年３月１２日 水曜日 午後２時４２分