Operation Manual

Air cleaner filter
Vehicle care and maintenance 9-9
9
The radiator cap must be sealed tight to pre-
vent losing coolant, which may result in
engine damage. Only use a Mitsubishi
Motors Genuine Parts radiator cap, or an
approved equivalent.
Do not overfill the reserve tank.
Your vehicle uses a special radiator cap
that stays sealed and lets the coolant flow
from the reserve tank back to the radiator
when the engine cools down. If you need
to change the cap, use the exact same
kind.
Check the coolant freeze point in the radi-
ator with the proper gauge, and only when
it is safe. If you add antifreeze, the con-
tents of the reserve tank must be protected
against freezing.
Keep the front of the radiator and con-
denser clean.
If the engine coolant temperature does not
rise after the engine is warmed-up, take
your vehicle to an authorized Mitsubishi
Motors dealer or a repair facility of your
choice to have the thermostat checked,
and replaced if necessary.
N00937901410
The air cleaner filter will get dirty and dusty
from use and not filter properly. Replace it
with a new filter using the schedule in the
“WARRANTY AND MAINTENANCE
MANUAL”.
1. For 2.4 L models, remove the two clips
(A), then remove the Air duct (B).
2. For 2.4 L models, while holding down the
tab (C), pull out the connector (D).
3. Unclamp the cover. Open up the top of the
cover and take out the air cleaner filter.
Do not top off the tank with plain water only.
Water by itself boils at a lower temperature
and does not stop rust or freezing. If the
water freezes, it will damage your cooling
system. Do not use tapwater. It can cause
corrosion and rust.
Radiator cap
WARNING
Wait for the engine to cool down before
opening the radiator cap. Otherwise hot
steam or boiling coolant could spray up
from the radiator and scald you.
Points to remember
CAUTION
Air cleaner filter
BK0211800US.book 9 ページ 2014年3月12日 水曜日 午後2時42分