Operation Manual

Bluetooth® 2.0 interface (if so equipped)
Features and controls 5-205
5
6. When the transfer is complete, the voice
guide will say “Import complete” and
then the system will return to the main
menu.
N00566301092
MODEL: MMC FCC ID: CB2MDGMY10
IC: 279B-MDGMY10
Your Bluetooth
®
2.0 interface operates on a
radio frequency subject to Federal Communi-
cations Commission (FCC) Rules (For vehi-
cles sold in U.S.A.) and Industry Canada
Rules (For vehicles sold in Canada). This
device complies with Part 15 of the FCC
Rules and RSS-210 of the Industry Canada
Rules. Operation is subject to the following
two conditions:
 This device may not cause harmful inter-
ference.
 This device must accept any interference
received, including interference that may
cause undesired operation.
The term “IC:” before the radio certification
number only signifies that Industry Canada
technical specifications were met.
The antenna used for this transmitter must not
be co-located or operating in conjunction
with any other antenna or transmitter. End-
users and installers must be provided with
installation instructions and transmitter oper-
ating conditions for satisfying RF exposure
compliance.
FCC Notice: This equipment has been tested
and found to comply with the limits for a
Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, use and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio com-
munications.
However, there is no guarantee that interfer-
ence will not occur in a particular installation.
If this equipment does cause harmful interfer-
ence to radio or television reception, which
can be determined by turning the equipment
off and on, the user is encouraged to try to
correct the interference by one or more of the
following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the
equipment and receiver.
General information
CAUTION
 Changes or modifications made to this
equipment not expressly approved by the
manufacturer may void the FCC authoriza-
tion to operate this equipment.
 Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
 Consult the dealer or an experienced
radio/TV technician for help.
ICES Notice: This Class B digital apparatus
complies with Canadian ICES-003.
N00566401080
Enrollment commands
BK0211800US.book 205 ページ ２０１４年３月１２日 水曜日 午後２時４２分