Operation Manual

Bluetooth® 2.0 interface (if so equipped)
Features and controls 5-191
5
5. The voice guide will prompt for phrase 1.
Repeat the corresponding phrase listed in
table “Enrollment commands” on page
5-205.
The system will register your voice and
then move on to the registration of the
next command. Continue the process until
all phrases have been registered.
6. When all enrollment commands have
been read out, the voice guide will say
“Speaker enrollment is complete.” The
system will then end the speaker enroll-
ment process and return to the main
menu.
N00564901078
You can turn a voice model registered with
the speaker enrollment function on and off
whenever you want.
You can also retrain the system.
Use the following procedure to perform these
actions.
1. Press the SPEECH button (except for
vehicles with Mitsubishi Multi-Commu-
nication System) or PICK-UP button (for
vehicles with Mitsubishi Multi-Commu-
nication System).
2. Say “Voice training.”
3. If you have completed a speaker enroll-
ment process once already, the voice
guide will say either “Enrollment is
enabled. Would you like to disable or
retrain?” or “Enrollment is disabled.
Would you like to enable or retrain?”
4. When enrollment is “enabled,” the voice
model is on; when enrollment is “dis-
abled,” the voice model is off. Say the
command that fits your needs.
Say “Retrain” to start the speaker enroll-
ment process and recreate a new voice
model. (Refer to “Speaker enrollment” on
page 5-190.)
N00565001180
Before you can make or receive hands-free
calls or play music using the Bluetooth
®
2.0
interface function, you must pair the Blue-
tooth
®
device and Bluetooth
®
2.0 interface.
Up to 7 Bluetooth
®
devices can be paired
with the Bluetooth
®
2.0 interface.
NOTE
 If you do not start the speaker enrollment
process within 3 minutes after pressing the
SPEECH button, the speaker enrollment
function will time out.
The voice guide will say “Speaker enroll-
ment has timed out.” The system will then
beep and the voice recognition mode will be
deactivated.
NOTE
 To repeat the most recent voice training com-
mand, press and release the SPEECH button.
 If you press the HANG-UP button anytime
during the process, the system will beep and
stop the speaker enrollment process.
NOTE
 Completing the speaker enrollment process
will turn on the voice model automatically.
 The commands “Help” and “Cancel” will not
work in this mode.
Enabling and disabling the voice
model and retraining
Connecting the Bluetooth
®
2.0
interface and Bluetooth
®
device
NOTE
 Pairing is required only when the device is
used for the first time. Once the device has
been paired with the Bluetooth
®
2.0 inter-
face, all you need is to bring the device into
the vehicle next time and the device will
connect to the Bluetooth
®
2.0 interface auto-
matically (if supported by the device). The
device must have Bluetooth
®
turned ON to
connect.
BK0211800US.book 191 ページ ２０１４年３月１２日 水曜日 午後２時４２分