Operation Manual

Hazard warning flasher switch
Features and controls 5-177
5
N00522701328
If you press the flasher switch, the front and
rear turn signals will flash intermittently, and
so will the hazard warning lights. This is an
emergency warning system and should not be
used when the vehicle is in motion, except for
emergencies.
If you need to leave your vehicle, the flashers
will keep working after the ignition switch is
removed or the operation mode is put in OFF.
N00579300028
ECO mode is an eco-driving support system
which automatically controls the engine, air
conditioning system, 4WD system (if so
equipped) and S-AWC (if so equipped) to
improve fuel efficiency.
Refer to Electronically controlled 4WD sys-
tem” on page 5-74.
Refer to “S-AWC (Super-All Wheel Con-
trol)” on page 5-77.
Refer to “Automatic climate control air con-
ditioner” on page 7-5.
The ECO mode starts working by pressing
the ECO mode switch when the ignition
switch or operation mode is in ON.
Push the switch again and the ECO mode will
cancel.
NOTE
 A light in the instrument panel flashes to
show when the front and rear turn signal
lights are working properly.
If this light flashes faster than usual, check
for a burned out turn signal light bulb or mal-
functioning connection in the signal.
If the panel light does not come on when the
lever is moved, check for a blown fuse or a
burned out bulb in the panel.
Have the system inspected by your autho-
rized Mitsubishi Motors dealer or a repair
facility of your choice.
 It is possible to modify functions as follows:
• Deactivate the turn signal light 3-flash
function for lane changes.
• Adjust the time required to operate the
lever for the 3-flash function.
See your authorized Mitsubishi Motors
dealer for details.
For vehicles equipped with the Mitsubishi
Multi-Communication System, adjustments
can be made using screen operations. For
further details, refer to the separate owner’s
manual.
 It is possible to change the tone of a sound-
ing buzzer as the turn signal lights flash.
[Vehicle equipped with the multi information
display - type 1]
Refer to “Changing the turn-signal sound”
on page 5-139.
[Vehicle equipped with the multi information
display - type 2]
See your authorized Mitsubishi Motors
dealer for details.
Hazard warning flasher
switch
NOTE
NOTE
 If the flashers are used for several hours, the
battery will run down. This could make it
difficult or impossible to restart your vehicle.
ECO mode switch
BK0211800US.book 177 ページ ２０１４年３月１２日 水曜日 午後２時４２分