Operation Manual

Headlight leveling switch (if so equipped)
5-176 Features and controls
5
N00537101115
The direction of the headlight beam (the
direction in which the light shines) alters
according to the number of people and the
load in the vehicle. Lower the headlight angle
if it is too high due to the number of people
and/or the load in the vehicle so that the head-
lights’ glare does not distract the drivers of
approaching vehicles. First set the light
switch to the “ ” position, then turn the
headlight leveling switch knob to lower the
beam. The greater the number on the head-
light leveling switch knob, the lower the
beam will point.
Set the switch to the appropriate position so
that the headlight beam is level with the road.
N00522601529
When changing lanes, or to making a gradual
turn, hold the lever in the “lane change” posi-
tion (1). It will return to the neutral position
when you let go. Use the full position (2)
when making a normal turn. The lever will
return to the neutral position when the turn is
complete. There may be times when the lever
does not return to the neutral position. This
usually happens when the steering wheel is
turned only slightly. You can easily return the
lever by hand.
Also, when you move the lever to (1) slightly
then release it, the turn signal lights and the
indicator light in the instrument cluster will
flash three times.
• Turn the combination headlights and dim-
mer switch to the “ ” or “ ” position
or put the operation mode in ON.
• Turn the ignition switch to the “ON” posi-
tion or put the operation mode in ON.
 It is possible to modify functions as follows:
• The time that the headlights remain on can
be changed.
• The coming home light function can be
deactivated.
For details, consult a Mitsubishi Motors
dealer.
On vehicles equipped with Mitsubishi Multi-
Communication System, screen operations
can be used to make the adjustment.
Refer to separate owner’s manual for details.
Headlight leveling switch (if
so equipped)
NOTE
WARNING
 To avoid distraction while driving, always
perform headlight adjustments before
vehicle operation.
NOTE
 Start adjusting when the knob is at the “0”
position (when the beam is at its highest).
 Keep the knob in the “0” position except
when using the knob to lower the headlight
beam angle.
 Always return the knob to the “0” position
when the load is removed and the people
have left the vehicle.
Turn signal lever
BK0211800US.book 176 ページ ２０１４年３月１２日 水曜日 午後２時４２分