Operation Manual

Combination headlights and dimmer switch
Features and controls 5-175
5
N00563201117
This function turns on the front side-marker
and parking lights for about 30 seconds after
the UNLOCK button on the remote control
transmitter is pressed when the combination
headlights and dimmer switch is in the “OFF”
or “AUTO” position (for vehicles equipped
with the automatic light control). On vehicles
equipped with the automatic light control
(except for vehicles equipped with LDW), the
welcome light function will operate only
when it is dark outside the vehicle.
N00547301110
This function turns on the headlights in the
low beam setting for about 30 seconds after
the ignition switch is turned to the “OFF” or
“LOCK” position or the operation mode is
put in OFF.
1. Turn the combination headlights and dim-
mer switch to the “OFF” or “AUTO”
position (for vehicles equipped with the
automatic light control).
2. Turn the ignition switch to the “OFF” or
“LOCK” position or put the operation
mode in OFF. Also, if a key was used to
start the engine, remove the key from the
ignition switch.
3. Within 60 seconds of turning the ignition
switch to the “OFF” or “LOCK” position
or putting the operation mode in OFF, pull
the turn signal lever toward you.
4. The headlights will come on in the low
beam setting for about 30 seconds. After
the headlights go off, the headlights can
be turned on again in the low beam setting
for about 30 seconds by pulling the turn
signal lever toward you within 60 seconds
of turning the ignition switch to the
“OFF” or “LOCK” position or putting the
operation mode in OFF. To turn on the
headlights again after 60 seconds of turn-
ing the ignition switch to the “OFF” or
“LOCK” position or putting the operation
mode in OFF, repeat the process from step
1.
Welcome light
NOTE
 While the welcome light function is operat-
ing, perform one of the following operations
to cancel the function.
• Push the LOCK button on the remote con-
trol transmitter.
• Turn the combination headlights and dim-
mer switch to the “ ” or “ ” position.
• Turn the ignition switch to the “ON” posi-
tion or put the operation mode in ON.
 It is possible to modify functions as follows:
• The headlights can be set to come on in the
low beam setting.
• The welcome light function can be deacti-
vated.
For details, consult a Mitsubishi Motors
dealer.
On vehicles equipped with Mitsubishi Multi-
Communication System, screen operations
can be used to make the adjustment.
Refer to the separate owner’s manual for
details.
Coming home light
NOTE
NOTE
 While the coming home light function is
operating, perform one of the following
operations to cancel the function.
• Pull the turn signal lever toward you.
BK0211800US.book 175 ページ ２０１４年３月１２日 水曜日 午後２時４２分