Operation Manual

Combination headlights and dimmer switch
5-174 Features and controls
5
If the combination headlights and dimmer
switch is turned to the “ ” or “ ” posi-
tion again after the engine is turned off, the
about 3-minute auto-cutout function
described above will not work. The lights (the
parking lights, tail lights and license plate
lights) will stay on and will not turn off auto-
matically.
N00549801236
[When using a key to start the engine]
If the driver’s door is opened with the key in
the “OFF” or “LOCK” or “ACC” position or
removed from the ignition switch while the
lights are on, the tone will sound to remind
you to turn off the lights.
[When using the F.A.S.T.-key to start the
engine]
If the driver’s door is opened with the opera-
tion mode is put in OFF or ACC, or if the
operation mode is changed to OFF while the
lights are on, the tone will sound to remind
you to turn off the lights.
In either case, the lights will turn off automat-
ically and so will the tone. Or you can turn
the light switch to the “OFF” position to stop
the tone.
N00549901178
To change the headlights from high beam to
low beam and vice versa, pull the turn signal
lever to (1). Switch the headlights to low
beam as a courtesy whenever there are
oncoming vehicles, or when there is traffic
moving ahead of you. An illuminated blue
light in the instrument cluster indicates when
the headlights are on high beam.
N00550001209
You can flash the high beams by pulling the
lever gently toward you (2). The lights will
go back to normal when you let go. While the
high beam is on, you will see a blue light on
the instrument panel.
NOTE
 The light auto-cutout function can be deacti-
vated.
See your authorized Mitsubishi Motors
dealer for details.
For vehicles equipped with the Mitsubishi
Multi-Communication System, adjustments
can be made using screen operations. For
further details, refer to the separate owner’s
manual.
When you want to keep the lights
on:
Headlight reminder buzzer
Dimmer (high/low beam
change)
Headlight flasher
NOTE
 You can flash the high beams by pulling the
lever toward you, even if the light switch is
off.
 If you turn the lights off with the head lights
set to high-beam illumination, the headlights
are automatically returned to their low-beam
setting when the light switch is next turned
to the “ ” position.
BK0211800US.book 174 ページ ２０１４年３月１２日 水曜日 午後２時４２分