Operation Manual

Rear-view camera (if so equipped)
5-118 Features and controls
5
 A window tint that affects the radio wave
signals is installed.
N00532900081
If new wheels with new tire inflation pressure
sensors are installed, their ID codes must be
programmed into the tire pressure monitoring
system. Have tire and wheel replacement per-
formed by an authorized Mitsubishi Motors
dealer to avoid the risk of damaging the tire
inflation pressure sensors. If the wheel
replacement is not done by an authorized
Mitsubishi Motors dealer, it is not covered by
your warranty.
N00533001233
Your tire pressure monitoring system oper-
ates on a radio frequency subject to Federal
Communications Commission (FCC) Rules
(For vehicles sold in U.S.A.) and Industry
Canada Rules (For vehicles sold in Canada).
This device complies with part 15 of FCC
Rules and Industry Canada licence-exempt
RSS standard(s).
Operation is subject to the following two con-
ditions.
 This device may not cause harmful inter-
ference.
 This device must accept any interference
received, including interference that may
cause undesired operation.
N00546201196
When the selector lever is in the “R”
(REVERSE) position with the ignition switch
in the “ON” position, or the operation mode
is put in ON, the rear-view image will be dis-
played on the screen of the Mitsubishi Multi-
Communication System or the DISPLAY
AUDIO.
When the selector lever is shifted out of the
“R” (REVERSE) position, the rear-view
image will go off.
NOTE
 Tire inflation pressures vary with the ambi-
ent temperature. If the vehicle is subjected to
large variations in ambient temperature, the
tire inflation pressures may be under-inflated
(causing the warning light / display come on)
when the ambient temperature is relatively
low. If the warning light / display comes on,
adjust the tire inflation pressure.
Whenever the tires and wheels
are replaced with new ones
CAUTION
 The use of non-genuine wheels will prevent
the proper fit of the tire inflation pressure
sensors, resulting air leakage or damage of
the sensors.
General information
CAUTION
 Changes or modifications not expressly
approved by the manufacturer for compli-
ance could void the user’s authority to oper-
ate the equipment.
Rear-view camera (if so
equipped)
WARNING
 Never rely solely on the rear-view camera
to clear the area behind your vehicle.
Always check visually behind and all
around your vehicle for persons, animals,
obstructions or other vehicles. Failure to
do so can result in vehicle damage, serious
injury or death.
 The rear-view camera is an aid system for
backing up, but it is not a substitute for
your visual confirmation.
 The view on the screen is limited, and
objects outside the view, such as under the
bumper or around either corner of the
bumper end, cannot be seen on the screen.
BK0211800US.book 118 ページ ２０１４年３月１２日 水曜日 午後２時４２分