Operation Manual

Adaptive Cruise Control System (ACC) (if so equipped)
5-102 Features and controls
5
N00581500027
There are two ways to increase the set speed.
The set speed will increase by 1 mph (1
km/h) every time you push up the “RES +”
switch while the ACC is activated. If you
hold the switch pushed up, the set speed
increases in 5 mph (5 km/h) increments.
When the accelerator pedal is depressed
while driving with the ACC control working,
you can accelerate the vehicle beyond the
presently set speed.
When the vehicle speed reaches your desired
speed, push down and release the “SET -”
switch and release the accelerator pedal; the
new speed is then set in the system.
CAUTION
 To maintain proper performance of the ACC:
• Always clean the surface of the radar sen-
sor.
• Avoid impacting the radar sensor or its sur-
rounding area.
• Do not put a sticker on the radar sensor or
its surrounding area.
• Do not paint the radar sensor.
• Do not install a grill guard.
• Do not modify the radar sensor or its sur-
rounding area.
• Always use tires of the same size, same
type, and same brand, and which have no
significant wear differences.
• Do not modify the vehicle’s suspension.
To increase the set speed
By using the “RES +” switch:
NOTE
 There is some time lag until the vehicle
begins accelerating to the new set speed after
the set speed has been changed.
 The set speed can be changed even while
your vehicle is following a vehicle in front
using the ACC. In this case, however,
although the set speed itself is increased,
your vehicle will not accelerate.
 When the switch is held, a buzzer will sound
every time the set speed changes
By using the accelerator pedal:
WARNING
 The ACC braking control and approach
alarm functions will not work while the
accelerator pedal is depressed.
NOTE
 The set speed indicator in the multi informa-
tion display will show “---” while the accel-
erator pedal is depressed.
 If the “SET -” button is not pushed down
while depressing the accelerator pedal, your
vehicle speed will return to the set speed,
after the accelerator pedal is released. When
the accelerator pedal is released, the ACC
braking control and approach alarm func-
tions may not immediately work.
BK0211800US.book 102 ページ ２０１４年３月１２日 水曜日 午後２時４２分