Operation Manual

Adaptive Cruise Control System (ACC) (if so equipped)
5-96 Features and controls
5
Under either of the following conditions,
however, using the switch does not allow you
to resume the previously set speed. In these
situations, repeat the speed setting procedure:
 The CRUISE CONTROL ON/OFF
switch is pressed.
 The operation mode is put in OFF.
 Indicator go off.
N00576800035
ACC maintains a set speed with no need for
you to use the accelerator pedal. Using a sen-
sor (A), the system also measures the relative
speed and distance between your vehicle and
a vehicle in front, and maintains a set follow-
ing distance between your vehicle and the
vehicle in front by automatically decelerating
your vehicle if it becomes too close to the
vehicle in front.
The cruising set speed can be set from 25
mph (40 km/h) to 110 mph (180 km/h). The
distance can be selected from three levels.
If the vehicle in front decelerates, the ACC
will automatically apply limited braking to
maintain the distance, and if the front vehicle
then accelerates, the ACC will automatically
accelerate your vehicle up to the set speed. If
your vehicle is approaching too close to the
front vehicle, a buzzer will sound and a warn-
ing is shown in the multi information display.
When the ACC detects no vehicle ahead, the
set speed will be maintained.
Conventional cruise control mode without the
distance control can also be selected.
Stop lights are illuminated during automatic
braking.
N00577000021
Adaptive Cruise Control
System (ACC)
(if so equipped)
WARNING
 Before using the ACC, read this entire sec-
tion to understand the limitations of this
system. Failure to follow instructions
could result in an accident.
 Never rely solely on the ACC. The ACC is
not a collision avoidance system or an
automatic driving system. It is designed to
use only limited braking and is never a
substitute for your safe and careful driv-
ing. Always be ready to apply the brakes
manually.
Cruise control switch
1- “ACC ON/OFF” switch
Used to turn on and off the ACC sys-
tem.
2- “SET -” switch
Used to set a desired speed or to reduce
the set speed.
BK0211800US.book 96 ページ ２０１４年３月１２日 水曜日 午後２時４２分