Operation Manual

Cruise control
Features and controls 5-95
5
N00518801575
The set speed driving can be deactivated as
follows:
 Press the CRUISE CONTROL ON/OFF
switch (A) (Cruise control will be turned
off.)
 Press the CANCEL switch (D).
 Depress the brake pedal.
The set speed driving is deactivated automati-
cally in any of the following ways.
 When your speed slows to about 10 mph
(15 km/h) or more below the set speed
because of a hill, etc.
 When your speed slows to about 25 mph
(40 km/h) or less.
 When the active stability control (ASC)
starts operating. (if so equipped)
Refer to “Active stability control (ASC)”
on page 5-89.
Also, the set speed driving may be deacti-
vated as follow:
 When the engine speed rises and
approaches the tachometer’s red zone (the
red-coloured part of the tachometer dial).
N00518901345
If the set speed driving is deactivated by the
condition described in “To deactivate” on
page 5-95, you can resume the previously set
speed by push up the RES+ switch (C) while
driving at a speed of about 25 mph (40 km/h)
or higher.
The “SET” indicator appears on the informa-
tion display in the meter cluster. (For vehicles
equipped with the color liquid crystal display
meter)
To deactivate
WARNING
 Although the set speed driving will be
deactivated when shifting to the “N”
(NEUTRAL) position, never move the
selector lever to the “N” (NEUTRAL)
position while driving.
You would have no engine braking and
could cause a serious accident.
CAUTION
 When the set speed driving is deactivated
automatically in any situation other than
those listed above, there may be a system
malfunction.
Press the CRUISE CONTROL ON/OFF
switch to turn off the cruise control and have
your vehicle inspected by an authorized Mit-
subishi Motors dealer or a repair facility of
your choice.
To resume the set speed
BK0211800US.book 95 ページ ２０１４年３月１２日 水曜日 午後２時４２分