Operation Manual

S-AWC (Super-All Wheel Control) (if so equipped)
Features and controls 5-79
5
N00583100027
The currently selected control mode is dis-
played on the multi-information display.
In addition, when the control mode is
changed, the selected mode appears on the
interrupt display screen of the information
screen in the multi-information display.
The control mode display will appear on the
information screen for a few seconds, and
then the original screen will return.
Warning display
Warning display
N00542501058
The S-AWC operation status can be displayed
on the information screen in the multi-infor-
mation display.
To display the status, press the multi-informa-
tion meter switch to change the information
screen.
Refer to “Information screen (when the oper-
ation mode in ON)” on page 5-126.
The S-AWC operation status is displayed.
NOTE
 The control mode can be switched while
driving or stopped.
S-AWC control mode display
Example: “AWC ECO” mode is selected.
CAUTION
 If the selected drive mode indicator begins
blinking, the drive mode will automatically
switch to protect the drive-system compo-
nents. A warning will also be displayed in
the information screen in the multi informa-
tion display.
Reduce speed and, if the indicator stops
blinking, you may resume normal driving.
CAUTION
 If the selected drive mode indicator (4WD) is
blinking, a problem has occurred with the
electronically controlled 4WD. A warning
will also be displayed in the information
screen in the multi information display. Have
your vehicle inspected by an authorized Mit-
subishi Motors dealer.
CAUTION
 Make sure that all four tires are the same
specified size, type, and brand, and have no
significant difference in the amount of wear
for all 4 wheels. Otherwise, the S-AWC sys-
tem may not work properly, and a 4WD sys-
tem warning (overheating or service
required) may be displayed.
S-AWC operation display
Display example
BK0211800US.book 79 ページ ２０１４年３月１２日 水曜日 午後２時４２分