Operation Manual

Automatic transaxle (if so equipped)
5-62 Features and controls
5
N00513901441
When the operation mode is put in ON, the
selector lever position is shown on the multi-
information display.
N00514001276
[For vehicles equipped mono-color liquid
crystal display meter]
When the selector lever position indicator
blinks while you are driving, there could be a
malfunction in the automatic transmission
system or A/T fluid temperature becomes
abnormally high.
[For vehicles equipped with color liquid
crystal display meter]
or
When the warning display or the warn-
ing display appears on the information screen
Selector lever position display
Warning display
When the selector lever position
indicator blinks
Type 1 Type 2
NOTE
 “A” indicator blinks only if the A/T posi-
tional switch is broken.
It does not indicate in normal driving condi-
tion.
CAUTION
 If a malfunction occurs in the A/T while
driving, the indicator will blink.
In this case, immediately park your vehicle
in a safe place and follow these procedures:
[If the indicator blinks rapidly (once per sec-
ond), the A/T fluid is overheating.]
Park your vehicle in a safe place but do not
turn off the engine. Move the selector lever
to the “P” (PARK) position and open the
bonnet. Keep the engine, idling.
After a while, move the selector lever into
any position other than “P” (PARK) position
and confirm that the indicator stops blinking.
It is safe to continue driving if the indicator
no longer blinks.
If the indicator continues blinking or blinks
intermittently, have your vehicle inspected
by an authorized Mitsubishi Motors dealer.
[If the indicator blinks slowly (once per 2
seconds), the A/T safety device may be oper-
ating due to a malfunction.]
Have the vehicle inspected by an authorized
Mitsubishi Motors dealer as soon as possi-
ble.
BK0211800US.book 62 ページ ２０１４年３月１２日 水曜日 午後２時４２分