Operation Manual

Theft-alarm system
5-44 Features and controls
5
N00510201267
The theft-alarm system is designed to provide
protection from unauthorized entry into the
vehicle. This system is operated in three
stages: the first is the “armed” stage, the sec-
ond is the “alarm” stage, and third is the “dis-
armed” stage. If triggered, the system
provides both audible and visual alarm sig-
nals.
N00510301200
Park the vehicle and stop the engine. Arm the
system as described below.
1. Except for vehicles equipped with the
F.A.S.T.-key, remove the key from the
ignition switch.
For vehicles equipped with the F.A.S.T.-
key, put the operation mode in OFF.
2. Make sure that the engine hood is closed.
3. Lock all doors and the liftgate by using
the keyless entry system or the F.A.S.T.-
key operation.
At this time, the theft-alarm indicator (A)
on the instrument panel flashes for confir-
mation.
4. The system has entered the armed stage
after about 20 seconds, when the theft-
alarm indicator (A) flashing becomes
slower.
The theft-alarm indicator (A) continues to
flash while the system is in the armed
stage.
CAUTION
 Always keep the release lever lid on the lift-
gate closed when driving so that your lug-
gage cannot accidentally bump the lever and
open the liftgate.
Theft-alarm system
CAUTION
 Do not modify or add parts to the theft-alarm
system. Doing so could cause the theft-alarm
to malfunction.
Armed stage
Arm the system and leave
NOTE
 If the engine hood is open, the theft-alarm
indicator (A) illuminates and the system can-
not enter the armed stage.
The system enters the armed stage about 20
seconds after the engine hood is closed.
 The system will be disarmed if, while the
theft-alarm indicator (A) is illuminated, all
doors and the liftgate are unlocked by using
the keyless entry system or the F.A.S.T.-key
operation.
 The system will be disarmed if, while the
theft-alarm indicator is illuminated, the fol-
lowing operation is performed.
BK0211800US.book 44 ページ ２０１４年３月１２日 水曜日 午後２時４２分