Operation Manual

Child restraint systems
4-30 Seat and restraint systems
4
4. Latch the tether strap hook (E) of the child
restraint system to the tether anchor bar
(F) and tighten the tether strap so it is
securely fastened.
5. Push and pull the child restraint system in
all directions to ensure it is firmly
secured.
N00407301465
With the exception of the driver, the seat belt
in all other seating positions can be converted
from normal Emergency Locking Retractor
(ELR) mode, to Automatic Locking Retractor
(ALR) mode. This means that when you pull
the seat belt fully out of the retractor, the
retractor will switch to its ALR child restraint
installation function. Always use the ALR
child restraint installation function when you
install a child restraint system using the seat
belt.
Children 12 years old and under should
always be restrained in the rear seat, when-
ever possible, although the front passenger
seat belt can also be converted to ALR mode.
D- Connector
NOTE
 In order to secure a child restraint system
compatible with the LATCH system, use the
lower anchor points in the outboard positions
of the second row seat. It is not necessary to
use the vehicle’s seat belt. The vehicle’s seat
belt, however, MUST be used to secure a
child restraint system in the middle seating
position of the second row seat.
WARNING
 If there is any foreign material in or
around the lower anchors, remove it
before installing the child restraint sys-
tem. Also, make sure the seat belt is away
from, not looped through or otherwise
interfering with, the child restraint sys-
tem. If foreign matter is not removed
and/or the seat belt interferes with the
child restraint system, the child restraint
system will not be secured properly, could
detach and move forward in the event of
sudden braking or an accident, and could
result in injury to the child or other vehi-
cle occupants.
 When the vehicle is moving, do not adjust
the seat where the child restraint system is
installed.
NOTE
 If it is difficult to latch the tether strap hook,
turn the hook sideways.
WARNING
 Child restraint system tether anchors are
designed only to withstand loads from cor-
rectly fitted child restraint systems. Under
no circumstances are they to be used for
adult seat belts, harnesses, for attaching
other items, or equipment to the vehicle.
Installing a child restraint sys-
tem using the seat belt (with
emergency/automatic locking
mechanism)
BK0200500US.book 30 ページ ２０１３年２月１２日 火曜日 午前９時４６分