Operation Manual

Replacement of light bulbs
Vehicle care and maintenance 9-37
9
3. Turn the socket counterclockwise to
remove it.
4. While holding down the tab (F), pull out
the bulb (G).
5. To install the bulb, perform the removal
steps in reverse.
N00943701501
1. Open the liftgate.
2. Remove the screws (A), and then move
the light unit toward the rear of the vehi-
cle to unfix the notch (B) and pins (C).
3. Turn the socket counterclockwise and
remove it, and then remove the bulb from
the socket by turning it counterclockwise
while pressing in.
4. To install the bulb, perform the removal
steps in reverse.
D- Front fog light
E- Daytime running light
Type 1
Type 2
Type 3
Rear combination lights
Front fog light Daytime running light
D- Tail and stop light
E- Rear turn signal light
NOTE
 The rear side-marker light uses an LED
instead of the bulb.
Check with an authorized Mitsubishi Motors
dealer or a repair facility of your choice
when the light needs to be repaired or
replaced.
BK0200500US.book 37 ページ ２０１３年２月１２日 火曜日 午前９時４６分