Operation Manual

Multi Information display - Type 1
Features and controls 5-133
5
N00578600024
While driving, the momentary fuel consump-
tion is shown with a bar graph.
The “ ” mark in the momentary fuel gauge
shows the average fuel consumption.
When the momentary fuel consumption sur-
passes the average fuel consumption, the
momentary fuel consumption is displayed
with a green bar graph.
Be conscious of maintaining the momentary
fuel consumption above the average fuel con-
sumption, it can help you drive with the better
fuel consumption.
N00568701032
This indicator will be displayed when fuel-
efficient driving is achieved.
N00578700025
This function displays how fuel-efficiently
you are driving under different driving condi-
tions.
The ECO drive assist display will change as
follows if you do fuel-efficient driving using
the accelerator in a way well matched with
the vehicle speed.
N00578800026
ECO score indicates the points you have
scored on fuel-efficient driving by the num-
ber of leaves as follows:
[When the ignition switch or the operation
mode is ON]
The display shows the score you achieved in
the last several minutes.
[When the ignition switch is turned to the
“OFF” or “LOCK” position or the operation
mode is put in OFF]
The display shows the overall ECO score the
function has counted from the time when the
ignition switch is turned to the “ON” position
to the time when it is turned to the “OFF” or
“LOCK” or “ACC” position, or from the time
NOTE
 The average speed display can be reset sepa-
rately in both auto reset mode and manual
reset mode.
 “---” is displayed when the average speed
cannot be measured.
 The initial (default) setting is “Auto reset
mode”.
 The display setting can be changed to the
preferred units (mph or km/h).
Refer to “Changing the function settings” on
page 5-134.
 Disconnecting the battery cable will erase
from memory the manual reset mode or auto
reset mode setting for the average speed dis-
play.
Momentary fuel consumption
display
NOTE
 When the momentary fuel consumption can-
not be measured, a bar graph is not shown.
 The display setting can be changed to the
preferred units {mpg (US), mpg (UK),
L/100km or km/L}.
Refer to “Changing the function settings” on
page 5-134.
 It is possible to cancel the green bar graph.
Refer to “Changing the function settings” on
page 5-134.
ECO indicator
ECO Drive Assist
ECO Score
ECO drive level
Low High
BK0200500US.book 133 ページ ２０１３年２月１２日 火曜日 午前９時４６分