Operation Manual

Rear-view camera (if so equipped)
Features and controls 5-119
5
Reference lines and upper surface of the rear
bumper (A) are displayed on the screen.
 Red line (B) indicates approximately 20
inches (50 cm) behind the rear bumper.
 Two Green lines (C) indicate approxi-
mately 8 inches (20 cm) outside of the
vehicle body.
 Short transverse lines (1 to 3) indicate dis-
tance from the rear bumper.
Reference lines on the screen
1: Approximately at the rear edge of the
rear bumper
2: Approximately 39 inches (100 cm)
3: Approximately 79 inches (200 cm)
CAUTION
 The rear-view camera uses a wide-angle
lens. As a result, images and distances shown
on the screen are not exact.
 Actual distance may be different from dis-
tance indicated by the lines on the screen,
depending on the loading condition of the
vehicle and road surface condition.
The reference lines for distance and vehicle
width are based on a level, flat road surface.
In the following cases, objects shown on the
screen will appear to be farther off than they
actually are.
• When the rear of the vehicle is weighed
down with the weight of passengers and
luggage in the vehicle. (Case 1)
• When there is an upward slope at the back.
(Case2)
Case 1
A- Actual objects
B- Objects shown on the screen
CAUTION
 The reference lines for distance and vehicle
width are intended to indicate the distance to
a flat object such as a level, flat road surface.
They may not indicate correct distance
depending on the shape of an obstacle.
For example, when there is an object behind
the vehicle that has upper sections projecting
in the direction of the vehicle, the reference
lines on the screen will indicate that point A
is the farthest point and point B is the closest
point to the vehicle. In reality, point A and B
are actually the same distance from the vehi-
cle, and point C is farther off than point A
and B.
Case 2
A- Actual objects
B- Objects shown on the screen
BK0200500US.book 119 ページ ２０１３年２月１２日 火曜日 午前９時４６分