Operation Manual

Tire pressure monitoring system
5-114 Features and controls
5
The alarm shown below is displayed if the
system becomes temporarily unavailable due
to the high temperature of the LDW camera.
After the camera has cooled down, the system
will automatically return to operation.
If the LDW is deactivated due to a malfunc-
tion in the system, the alarm shown below is
displayed. Contact your authorized Mitsubi-
shi Motors dealer for inspection of the sys-
tem.
N00530201481
The tire pressure monitoring system uses tire
inflation pressure sensors (A) on the wheels
to monitor the tire inflation pressures. The
system only indicates when a tire is signifi-
cantly under-inflated.
LDW camera is too hot
NOTE
 The warning message can be cleared tempo-
rarily by setting the LDW switch to “OFF.”
LDW deactivation due to fault
Tire pressure monitoring
system
WARNING
 The compact spare wheel does not have a
tire inflation pressure sensor.
When the spare tire is used, the tire pres-
sure monitoring system will not work
properly.
See an authorized Mitsubishi Motors
dealer as soon as possible to replace or
repair the original tire.
NOTE
 The tire pressure monitoring system is not a
substitute for regularly checking tire infla-
tion pressures.
Be sure to check the tire inflation pressures
as described in “Tires” on page 9-14.
 The tire inflation pressure sensor (A) is
installed in the illustrated location.
• On vehicles with Type 1 sensor which has
the rubber air valve (B), replace grommet
and washer (C) with a new one when the
tire is replaced.
• On vehicles with Type 2 sensor which has
the rubber sir valve (D), replace rubber
valve (D) with new one when the tire is
replaced.
BK0200500US.book 114 ページ ２０１３年２月１２日 火曜日 午前９時４６分