Operation Manual

Adaptive Cruise Control System (ACC) (if so equipped)
5-104 Features and controls
5
N00582800027
Simply depress the accelerator pedal to tem-
porarily accelerate the vehicle. Releasing the
pedal automatically slows down the vehicle
to the set speed and ACC restarts its control.
N00581700029
There are two ways to cancel the ACC con-
trol.
 By pressing the “CANCEL” switch.
 By depressing the brake pedal.
When the ACC is canceled, the “SET” indi-
cator goes off and the following distance indi-
cator turns to the ‘standby’ display. The front
vehicle indicator also turns to the ‘standby’
display when a front vehicle is detected.
In any of the situations listed below, the ACC
control is automatically canceled, a buzzer
sounds and a message is shown in the multi-
information display.
NOTE
 The ACC control will not resume after
releasing the brake pedal.
To temporarily accelerate the
vehicle
WARNING
 The ACC braking control and approach
alarm functions will not work while the
accelerator pedal is depressed.
NOTE
 The set speed indication on the display turns
to “---” when the accelerator pedal is
depressed. This indication remains as long as
the pedal is in a depressed position.
 In certain conditions, the braking control and
alarming functions of ACC may not work for
a short while after releasing the accelerator
pedal.
To cancel ACC control
NOTE
 You can also cancel the ACC control by
pressing the “ACC ON/OFF” switch. If this
switch is pressed while the ACC is “ON”,
the ACC will be turned off.
BK0200500US.book 104 ページ ２０１３年２月１２日 火曜日 午前９時４６分