Operation Manual

Continuously variable transmission (CVT) (if so equipped)
Features and controls 5-69
5
N00563301059
When the selector lever cannot be shifted
from the “P” (PARK) position to another
position while the brake pedal is pressed and
held down with the ignition switch at the
“ON” position or the operation mode in ON,
the battery may be flat or the shift-lock mech-
anism may be malfunctioning.
Immediately have your vehicle checked by an
authorized Mitsubishi Motors dealer or a
repair facility of your choice.
If you need to move the vehicle, shift the
selector lever as follows.
1. Make sure the parking brake is fully
applied.
2. Stop the engine if it is running.
Set the selector lever in the gate to
operate while the brake pedal is
depressed.
Set the selector lever in the gate to
operate.
For vehicles equipped without shift paddles
For vehicles equipped with shift paddles
WARNING
 Always press the brake pedal when shift-
ing the selector lever into a selector posi-
tion from the “N” (NEUTRAL) position.
When beginning to drive, do not shift the
selector lever from the “N” (NEUTRAL)
position while pressing the accelerator
pedal. This will cause the vehicle to
“jump” forward or backward.
NOTE
 To prevent mistakes in operating the lever,
make sure you stop briefly at each position.
After operating, check the position in the
multi-information display.
 If the brake pedal is not depressed and held,
the shift-lock device activates to prevent the
selector lever from being moved from the
“P” (PARK) position.
 For a shift indicated by in the illustra-
tion, depress the brake pedal before moving
the selector lever. If you attempt to move the
selector lever before depressing the brake
pedal, the selector lever may be immovable.
When the selector lever cannot be
shifted from the “P” (PARK) posi-
tion
BK0200500US.book 69 ページ ２０１３年２月１２日 火曜日 午前９時４６分