Operation Manual

Automatic transaxle (if so equipped)
5-60 Features and controls
5
2. While depressing the brake pedal, press
the accelerator pedal halfway and hold it
there, then crank the engine. Release the
accelerator pedal, immediately after the
engine starts.
3. If the engine still will not start, the engine
could be flooded with too much gasoline.
While depressing the brake pedal, push
the accelerator pedal all the way down
and hold it there, then crank the engine for
5 to 6 seconds. Return the ignition switch
to the “OFF” or “LOCK” position and
release the accelerator pedal. Wait a few
seconds, and then crank the engine again
for 5 to 6 seconds while depressing the
brake pedal, but do not push the accelera-
tor pedal. Release the ignition key if the
engine starts. If the engine fails to start,
repeat these procedures. If the engine still
will not start, contact your local Mitsubi-
shi Motors dealer or a repair facility of
your choice for assistance.
When the ambient temperature is -22 °F (-30
°C) or lower, it may not be possible to start
from a standstill even with the selector lever
in the “D” (DRIVE) position.
This occurs because the transaxle has not
warmed up sufficiently; it does not indicate a
problem. If this occurs, place the selector
lever in the “P” (PARK) position and let the
engine idle for at least 10 minutes.
The transaxle will warm up, and you will be
able to start normally.
Do not leave the vehicle during warm-up
operation.
The MIVEC engine automatically switches
its intake-valve control between a low-speed
mode and a high-speed mode in accordance
with driving conditions for maximum engine
performance.
N00513200216
Automatic transaxle will automatically
change its gear depending on road and driv-
ing conditions. This helps achieve smooth
driving and excellent fuel efficiency.
Also you can manually shift up and shift
down the transaxle. Refer to “Sports mode”
on page 5-65.
The transaxle prevents unnecessary upshifts
even when the accelerator pedal is released
and ensures smooth driving.
According to the conditions, the transaxle
will automatically shift to a lower gear to
achieve stronger engine braking. This may
help reduce your need to use the service
brake.
Startability of automatic transaxle
vehicle and CVT vehicle with
ambient temperature of -22 °F (-30
°C) or lower
Using the MIVEC engine
NOTE
 To protect the engine, the high-speed mode
may not be selected while the engine coolant
temperature is low. In such a case, the engine
revolutions do not rise to over 5,000 rpm
even if the accelerator pedal is depressed.
Automatic transaxle (if so
equipped)
DRIVING UPHILL
DRIVING DOWNHILL
BK0200500US.book 60 ページ ２０１３年２月１２日 火曜日 午前９時４６分