Operation Manual

Free-hand Advanced Security Transmitter (F.A.S.T.-key) (if so equipped)
Features and controls 5-31
5
N00562001062
N00562101076
1. Before replacing the battery, remove static
electricity from your body by touching a
metal grounded object.
2. With the Mitsubishi mark facing you,
insert the cloth-covered tip of a flat blade
screwdriver into the notch in the case and
use it to open the case.
3. Remove the old battery.
4. Install a new battery with the +side (A)
up.
5. Close the case firmly.
6. Check the keyless entry system to see that
it works.
 To use the new remote control transmitters, it
is necessary to register the key with both the
electronic immobilizer and keyless entry sys-
tem.
Also refer to “Electronic immobilizer (Anti-
theft starting system): Customer F.A.S.T.-
key programming” on page 5-27.
General information
Your F.A.S.T.-key operates on a radio fre-
quency subject to Federal Communications
Commission (FCC) Rules (For vehicles sold
in U.S.A.) and Industry Canada Rules (For
vehicles sold in Canada). This device com-
plies with Part 15 of FCC Rules and Industry
Canada licence-exempt RSS standard(s).
Operation is subject to the following two con-
ditions.
•This device may not cause harmful
interference.
•This device must accept any interference
received, including interference that
may cause undesired operation.
NOTE
CAUTION
 Changes or modifications not expressly
approved by the manufacturer for compli-
ance could void the user’s authority to oper-
ate the equipment.
Procedure for replacing the
remote control transmitter bat-
tery
NOTE
 Be sure to perform the procedure with the
Mitsubishi mark facing you. If the Mitsubi-
shi mark is not facing you when you open the
case, the transmitter may come out.
NOTE
 You may purchase a replacement battery at
an electric appliance store.
 An authorized Mitsubishi Motors dealer can
replace the battery for you if you prefer.
+ side
- side
Coin type bat-
tery CR2032
BK0200500US.book 31 ページ ２０１３年２月１２日 火曜日 午前９時４６分