Instruction manual

Instruction manual 97
8.10 Two NVVRs in the same remote site
Note : This information is intended to be followed only by advanced technicians.
If the NHServer and the NVVRs are installed in the same LAN, no especial configurations are needed. However, if
there is a WAN between both modules and there are more than one NVVRs in the same remote site, some
special configurations are needed. Let’s see a diagram about how the system looks like :
In order to configure the system, the next steps must be followed :
1 –Configure the router as follows. Note that the IP addresses are examples :
2 – Stop the NVVR2
3 - Use whatever text editor to open the file NVVR_Settings.xml in the NVVR2 , stored in the folder where the
NVVR was installed (by default : c:\Program files\NetHunter\NVVR). Make the following changes framed in a
red square:
4 – Save and close the file NVVR_Settings.xml
5 – Start the NVVR2
6 – Register the NVVR1 in NH. Read the section where adding the NVVR is explained for more details.
7 – Register the NVVR2 in NH. The port must be filled in before the IP. In the port field set the value “47000”.
Read the section where adding the NVVR is explained for more details.