Instruction manual

Instruction manual 95
1 – Stop NHServer
2 – Open the file NHIPserver.exe.config by using any text editor. This file is saved in the NH installation
folder
3 – Change the value of the parameter “MitsubishiPortReconnectionManagerEnabled” to “False”
4 – Close and save the file NHIPserver.exe.config
5 – Start NHServer
WARNING
The file NHIPserver.exe.config is a very important configuration file. If there is any mistake on it, NHServer might stop working. Edit it carefully.
Don’t change any value unless your distributor tells you so. It’s recommendable to make a backup previously.
8.9 Auto log-off after an inactivity period
In some concrete scenarios, the NHClient PCs are installed in places where unauthorized users in NH might walk
around. In these cases, if the logged user leaves the place for a while, unauthorized people might watch footage
of the surveillance system. There are two options to cope with this security hole :
1. Activate the secure logon in Windows
2. Active the auto log-off in NHClient : When this capability is actived, if no activity is performed on the
NHClient PC during “x” minutes , a log-in window is shown. No actions can be performed until the
logged user logs in again.