Instruction manual

Instruction manual 83
6.2 Devices information list
This list shows devices information such as its server, name, ip address, location in the tree, live status, play
status, recording state and the number of real-time events received. It is very similar to the option Monitor in
NHClient.
The pending events column provides info about the real-time events received for a specific device, but only
those configured to be shown on the real-time events panel. It can be set to 0 by double-clicking on it. It’s useful
when end-users want to notice any event received for a specific device.
All columns allow descending or ascending sorting by clicking on them and can be placed in other position just by
dragging and dropping them.
6.3 Real-time events
Multiserver Monitor receives all the RT events sent by the devices and dispatched by the NHServers. This list
shows the same info as the one in NHClient . Read the section Real-time events in NHClient for more
information.
It’s also possible to view the live stream from the cameras that caused the event. To do so, double-click any
event from the list. When done, the module NHClient will be launched, it will connect to the corresponding
NHServer and will show Live images from the cameras of the event. The module NHClient must be installed on
the same PC and not running. Only users with Live rights are allowed to do it.
6.4 Settings
All the configuration data can be changed in this option. There are 3 different kind of settings : General, Servers
and Real-time event classification.
6.4.1 General
Three important parameters can be changed in this tab :
Default server port : Default network port for connecting to NHServer. Check your firewalls or network filters in
order to confirm that this port is opened on the NHServers computers. Don’t change it unless your Mitsubishi
distributor ask you for it.
Maximum number of RT events displayed : Same setting as in Settings  General in NHClient.
Language : Choose the language you would like to use.