Instruction manual

Instruction manual 81
6 Nethunter Multiserver Monitor
This module is able to monitor more than one NHServer. It’s suitable for multiserver architectures. However, it has
some limitations so it can’t replace NHClient for the main admin tasks.
WARNING
At start-up, this module retrieves information from all the registered servers. This operation might last a while. Please, be patient.
6.1 Servers and devices tree
All registered servers are shown in the tree on the left. For each server, its groups and devices are listed under it.
When any node in the tree is clicked with the left mouse button, all the devices located under it are shown in the
device information list.
When any node in the tree is clicked with the right mouse button, a pop-up menu is shown with the following
commands :
Connect : Tries to establish the connection to that NHServer. This
option is only enabled when that server is disconnected.
Start NHClient : NHClient is launched,but with the Settings option
disabled. The module NHClient must be installed on the same PC and
not running. It automatically connects and opens a session to that
NHServer with the user / password configured in settings. This option
is only enabled when that server is connected.
Remove real-time events configuration : All the local real-time
events configuration for that server is removed. The next time
Multiserver Monitor connects to that server, the configuration will be
retrieved. This option is only enabled when that server is connected