Instruction manual

Instruction manual 31
3.5.6.1 Icons when broadcasting audio
When any IP camera is broadcasting audio, it’s possible to show icons warning users about it. Beside them, the
name of the camera is shown.
In order to enable it, the value of an internal parameter has to be set to “True”. To do so, follow the next steps :
1 – Stop NHClient
2 – Open the file NHIPclient.exe.Config by using any text editor. This file is saved in the NH installation
folder
3 – Change the value of the parameter “AudioIconsAreVisible” to “True”
4 – Close and save the file NHIPclient.exe.Config
5 – Start NHClient
When this parameter is set to “True”, the splits size is reduced so camera images will be shown smaller.
WARNING
The file NHIPclient.exe.config is a very important configuration file. If there is any mistake on it, NHClient might stop working. Edit it carefully.
Don’t change any value unless your distributor tells you so. It’s recommendable to make a backup previously.
The audio icons and the camera names are shown on the top of the splits. See in the picture below how they
look like.