Instruction manual

Page 9 of 10
TSB−12−66−001
When connecting the iPod adapter and a 1 DIN size add−on (6−disc CD changer) simultaneously
.
Head unit
6 disc CD changer
iPod
Dock connector
(1) Adapter
main unit
Vehicle−side 14P connector
Intermediate connector
(MZ598118EX; sold
separately)
13P
20P
Connect to B+ terminal
Fuse
Use tape, etc. to
protect the terminals
(3) Power cord
Adapter Installation (other accessory using audio
head 13 pin DIN connection)
1. Install the iPod adapter as described in the installation
instructions for the model.
2. Connect the DIN cable (13 pin connector) from the
adapter to the 13 pin connector on the other accessory
(e.g. CD changer).
3. Route the dock connector into the glovebox.
4. Connect the iPod to the dock connector.
5. For both procedures − Turn the iPod’s volume control to at least 90% of maximum and control the
volume using the audio unit’s controls. Line noise and static may be heard if iPod volume is left at
lower levels.
TROUBLESHOOTING
KNOWN CONDITIONS
If the iPod adapter is incorrectly routed, the aux adapter and the satellite functions of the radio may be
disabled.
To correct this condition, use the following routing map as a guide. The aux adapter should be connected
to the radio and the iPod adapter to the aux adapter. If the vehicle is equipped with factory SIRIUS satellite
radio, the satellite receiver is connected to the iPod adapter.
Correct DIN cable routing
Radio
Aux
Adapter
iPod
Adapter
SAT Receiver
(if equipped)
Radio
Aux
Adapter
iPod
Adapter
SAT Receiver
(if equipped)
Incorrect DIN cable routing