Instruction manual

Page 7 of 10
TSB−12−66−001
MOUNTING THE ADAPTER
Mounting locations vary by model and model year.
Refer to the installation instructions included with
the adaptor for the correct location for your vehicle.
1. Wipe the bottom surface of the adapter clean (the
surface without the label).
2. Remove the pre−mask from one side of each piece of
double−sided tape and attach it to bottom surface of
the adapter
NOTE: If it is necessary to attach the double−sided tape to
the top surface (with the label), position the tape so
the label is not covered.
Bundle
harnesses
Existing harness
Remove audio unit
Example only. Location
varies by model
3. Refer to Group 54 of the service manual to remove the
audio unit. Refer to Group 52A to remove the floor
console side panels, glove box and trim, etc.
4. Route the 13 pin DIN cable behind the audio head unit.
Bundle excess cable and secure it to the existing
wiring harness behind the audio unit. Ensure it is
isolated from other components and the dash
structure to prevent buzzes, squeaks and rattles.
NOTE: If an additional component is installed, run the
power cord along with the DIN cable.
5. Bundle the dock connector cable and leave
approximately 8” (20cm) of cable unbundled at the
end.
6. Route the dock connector to the glove compartment to
allow for safe and secure storage of the iPod.
CONNECTIONS
BASIC CONNECTIONS
The adapter is connected to the main harness of the vehicle.