Instruction manual

Page 4 of 10
TSB−12−66−001
MODEL DIP SWITCH SETTINGSYEARHEAD UNIT
Galant MN141496
1 DIN, Single CD
2008
O
1, 2 and 4: ON
3: OFF
O
8701A250
2 DIN, Single CD
1, 2 and 4: ON
3: ON for Album Mode
OFF for ALL Song Mode
O
8701A251
2 DIN CD changer
Galant 8701A250
2 DIN, Single CD
2009
O
8701A251
2 DIN, 6 CD changer
DIP SWITCH SELECTION
1 2 3 4
Label
ON side
OFF side
Switch
Switch Section
Dip switch settings control the order the adaptor
processes files. This can be customized for “Album”
mode or “ALL Songs Mode” (see File Structure and
Playback later in this TSB) depending on the audio head
unit.
Dip switches are located on the side of the adaptor. Refer
to the chart above, or the instructions included with the
unit, to set the switches BEFORE installation.
BASIC OPERATION
CONNECTING THE iPOD
1. Connect the iPod to the dock connector.
When connected, the iPod is turned on and a check mark is displayed on the its screen.
Use the cap to protect the
dock connector when a iPod
is not connected.
iPod
Connect the adapter to the iPod with the
triangle marks facing up.
Triangle
marks
Cap
To the iPod
NOTE:
S When connected, the iPod can only be controlled by the audio unit controls.
S While connected, the iPod will be charged when the ignition switch is turned to ACC or ON (except
newer iPods and iPhones − see iPhone section for details).
S Ensure the iPod’s volume is set to at least 90% of maximum for best results.
2. With the iPod connected to the dock connector, push the CD button until the display changes to CD2.
3. Using the following control chart, navigate to the desired music and make selections and adjustments
using the vehicle’s audio controls (and/or steering wheel, if equipped).