Technical information

Page 9 of 54
TSB−11−66−001
Remote Engine Start Transmitter Operation
Before operating the transmitter, verify that:
The shifter is in the “P” (Parking) position.
All doors (including the rear gate and spare tire carrier) are securely closed.
The engine hood is securely closed
The vehicle key is removed from the ignition switch. For vehicles equipped with the F.A.S.T. Key,
the ignition switch is on the LOCK position.
The transmitter will not start the engine unless all of the above conditions are properly set.
Starting Engine
Stopping Engine
1. Push the request/function button. The indicator will
blink for approximately 2 seconds.
2. Push the start button while the indicator is blinking. The
engine starting signal will be transmitted when the indicat
or stays on for 3 seconds. When the engine starts, the haz
ard warning light on the vehicle will flash once.
1. Push the request/function button. The indicator will
blink for approximately 2 seconds.
2. Push the stop button while the indicator is blinking. The
engine stop signal will be transmitted when the indicator
stays on for 3 seconds.
NOTE: Extend the antenna if necessary. The transmitter signal will reach further when the antenna is
extended.
The remote engine starter will stop running after 10 minutes (factory default setting). The time setting
can be changed. Refer to “Setting Engine Idle Time” below.
Additional information on these transmitters is on the
Mitsubishi Dealer Link. (See Additional Resources at
the end of this TSB).
Part No. MZ360300EX
Part No. MZ360361EX
Indicator
Switch Lock SW
Switch Unlock SW
Function SW
Start SW
Stop SW
Key ring
Antenna
Indicator
Start button
Stop button
Request button