Technical information

Page 17 of 54
TSB−11−66−001
How to change the engine idling time in
the Remote Engine Start system?
See Setting Engine Idle Time
MZ360360EX/MZ360340EX,
MZ360272EX/MZ360271EX .
Can a second transmitter be programmed
to the Remote Engine Start system?
No. For safety reasons, only one remote can be
programed to a specific remote engine start system at
one time.
However, a replacement transmitter can be
programmed. See Replacement Transmitters.
Engine shuts off when the driver’s door is
opened.
This is normal operation of the system. Refer to the
Remote Engine Start system owner’s manual on the
Mitsubishi Dealer Link.
Parking lights do not flash after the engine
is started through the Remote Engine
Start system.
Flashing parking lights feature is only available on some
models. Refer to the Remote Engine Start system
owner’s manual on the Mitsubishi Dealer Link.
Indicator light on the transmitter does not
flash or stay on.
Verify that the transmitter is not being operated within 2
seconds of engine start/stop.
Verify batteries are properly installed in the transmitter.
Replace discharged transmitter battery.
Indicator light on the transmitter flashes
and stays on.
Verify the transmitter setup.
Fully extend the antenna on the transmitter or operate
the transmitter at a closer range
If the vehicle has been parked for more than two weeks,
turn the ignition switch to ACC and then back to OFF.
Wait three seconds or more and the system will be
reactivated.
If the buzzer of the remote start system sounds for
about three seconds when the key is inserted into the
ignition switch or the ignition switch is turned to “ON”,
there may be a possible faulty ECU or remote control.