Technical information

Page 15 of 54
TSB−11−66−001
Programming the Keyless Push Start System − Part No. MZ360340EX
No. Action Response
1 Close all doors, hood, and hatch. Get into the
vehicle and make sure the ignition is OFF.
N/A
2 Press the Engine Start button once, then wait for 3
to 5 seconds.
The indicator light on the transmitter switch
changes to orange.
3 Press the Engine Start button twice. The indicator light on the transmitter switch turns
off.
4 Within 10 seconds of the last step, press the
Engine Start button 12 times.
ECU beeps once.
5 Within 5 seconds of finishing Step 4, press the 3
buttons on the transmitter all at once and hold for 1
second or longer. HINT: It can be done in the
following order: press and hold Start, add Stop,
add
Function.
Buzzer on the transmitter sounds once, and the
“Start” and “Stop” lights begin blinking.
6 While “Start” and “Stop” are blinking, press the
Engine Start button 3 times.
ECU beeps once.
7 Press the “Stop” button on the transmitter for 1
second or more.
ECU beeps twice.
8 Within 10 seconds after the ECU beep, press the
Unlock button on the vehicle remote 3 times.
Door locks automatically lock and unlock. Then
several seconds later they lock and unlock again.
9 Remote Engine Start registration is complete.