Technical information

Page 14 of 54
TSB−11−66−001
Programming the KOS System
No. MZ360272EX MZ360340EX Response
1 Close all doors, hood and hatch. Get into the vehicle and make sure
the ignition is OFF. Remove the knob cap. Insert emergency key.
N/A
2 Turn emergency key to ACC pos-
ition, then back to Lock (OFF) 5
times within 10 seconds. Then
remove the key.
Turn emergency key from Lock
(OFF) to ACC. Wait 3 to 5
seconds. Return key to Lock
(OFF). Repeat 4 times within 10
seconds.
ECU beeps once.
3 Within 10 seconds after the beep
sounds, press the 3 buttons on
the transmitter all at once and
hold for 2 seconds or longer.
HINT: It can be done in the fol-
lowing order: press and hold
Start, add Stop, add Request.
Within 5 seconds of finishing
Step 2, press the 3 buttons on
the transmitter all at once and
hold for 1 second or more. HINT:
It can be done in the following
order: press and hold Start, then
add Stop, then add Function.
Buzzer on transmitter sounds
once and its indicator light will
start blinking.
Buzzer on transmitter sounds
once and its “Start” and “Stop”
lights will begin blinking.
4 While indicator lights are blinking,
insert the ignition key and turn to
ACC, then back to Lock (OFF).
Then remove the key.
While the “Start” and “Stop” lights
are blinking, insert the ignition
key and turn to ACC, then back
to Lock (OFF). Remove the key.
ECU beeps once.
5 Perform the engine stop opera-
tion by the remote controller.
HINT: Press the “Request”
button, then press the “Stop”
button, and hold both for 1
second or longer.
Perform the engine stop opera-
tion by the remote controller.
HINT: Press the “Stop” button
and hold for 1 second or longer.
ECU beeps twice.
6 Within 10 seconds after the ECU beep, press the unlock button on
the vehicle remote 3 times.
Door locks automatically lock and
unlock. Then several seconds
later they lock and unlock again.
7 Remote Engine Start registration is complete.
Press the unlock
button on the
KOS key 3 times