Technical information

Page 13 of 54
TSB−11−66−001
Programming the RKE System
No. MZ360271EX MZ360272EX MZ360340EX MZ360360EX Response
1 Close all doors and
hatch, but open
hood. Turn off
ignition and
remove key.
Close all doors,
hood and hatch.
Turn off ignition
and remove key.
Close all doors,
hood and hatch.
Turn off ignition
and remove key.
Close all doors and
hatch, but open
hood. Turn off
ignition and
remove key.
N/A
2 Insert ignition key. Turn the key to ACC position. Turn key back to Lock (OFF) 5
times within 10 seconds. Then remove the key from the ignition.
For MZ360340EX: Insert ignition key. Turn key from Lock (OFF) to ACC. Wait 3 to
5 seconds. Return key to Lock (OFF). Repeat 4 times within 10 seconds.
ECU beeps once.
3 Within 10 seconds after the beep
sounds, press the 3 buttons on the
transmitter all at once and hold for 2
seconds or longer. HINT: It can be done
in the following order: press and hold
Start, add Stop, add Request.
Within 5 seconds after the beep sounds,
press the 3 buttons on the transmitter all
at once and hold for 1 second or more.
HINT: It can be done in the following
order: press and hold Start, then add
Stop, then add Function.
Buzzer on trans-
mitter sounds once
and its indicator
light will start
blinking.
Buzzer on trans-
mitter sounds once
and its “Start” and
“Stop” lights will
begin blinking.
4 While indicator lights are blinking, insert
the ignition key and turn to ACC, then
back to Lock (OFF). Then remove the
key.
While the “Start” and “Stop” lights are
blinking, insert the ignition key and turn
to ACC, then back to Lock (OFF). Then
remove the key.
ECU beeps once.
5 Perform the engine stop operation by
the remote controller. HINT: Press the
“Request” button, then press the “Stop”
button and hold both for 1 second or
longer.
Perform the engine stop operation by
the remote controller. Hint: Press the
“Stop” button and hold for 1 second or
more.
ECU beeps twice.
6 N/A Within 10 seconds after the ECU beep,
press the unlock button on the vehicle
remote 3 times.
N/A Door locks
automatically lock
and unlock. Then
several seconds
later they lock and
unlock again.
7 Remote Engine Start registration is completed.
Press unlock
button 3 times