Owner`s manual

- 8 -
C. INSTALLING THE ANTENNA UNIT
1) Cut the urethane sheet ④ into the following
dimensions.
A: 35 x 140 mm (2 pieces)
B: 70 x 20 mm (4 pieces)
C: 70 x 70 mm (1 piece)
D: 70 x 10 mm (1 piece)
2) Wrap the two pieces of urethane sheet A ④
around the cable of the antenna unit ②.
3) Pass the cable of the antenna unit ② into the
backside of the instrument panel at the bottom of
the front pillar.
4) Bind the antenna unit ② to the roof harness
using the three pieces of urethane sheet B ④.
Check
A
A
BB B
B
C
D