Owner`s manual

- 5 -
INSTALLATION PROCEDURES FOR ECLIPSE/SPYDER
A. PREPARATORY WORK
1) Confirm that the ignition key is removed and all the
electrical switches are off. Then disconnect the
battery (–) cable from the battery.
2) Remove the following parts in accordance with the
workshop manual.
1. Instrument panel side cover
2. Instrument lower panel assembly
3. Steering column upper cover
4. Steering column lower cover
5. Combination meter assembly
6. Cowl side trim
7. Front pillar trim
B. ROUTING THE HARNESS
1) Route the harness ③ along the vehicle harness as shown in the following two drawings.
Check
Do not fix the harness ③ yet. It should be fixed after completing all the connecting works.
Caution
!
Note
Details of sections C to H are shown in the following steps.