Owner`s manual

- 40 -
(3) Operation check
Perform the operation check in the following procedure while referring to the owner's manual.
1) Set the vehicle in the following conditions.
- Set the shift lever in the "P" position and apply the parking brake.
- Remove the ignition key from the key cylinder.
- Close all the doors (including backdoor and trunk lid) and hood.
2) Check the engine start operation
OK
NG
OK
Check
The en
g
ine starts.
Perform the en
g
ine start o
p
eration.
3) Check the hazard answer-back function.
Are hazard warning lamps flash once when the engine is starting?
Are the hazard warning lamps flash three times if the engine start
operation is performed while the engine is starting?
OK
Check
!
On ENDEAVOR models, make sure to set the interior light switch to "ROOM" position before proceeding.
Caution
!
OK
4) Check the engine stop operation.
Perform the engine stop operation.
The en
g
ine sto
p
s.
OK
NG
Check
Faulty ECU
NG
Go to
Troubleshooting D.
OK
Go to
Troubleshooting C.